این محصول به صورت تعداد موجود میباشد . لطفا در صورت نیاز به خرید بیش از یک عدد از طریق گفتگو اطلاع بدید. Introduction The power supply of the driver must not be reversed. It is recommended to connect the 15A fuse in series at the power interface. The voltage should be between 5V and 27V . If the voltage is over voltage, powering up may burn the drive module. It is recommended that the rated output current of the power supply be more than 2 times of the rated current of the motor, so as to prevent the power supply from supplying the current required by the motor to cause the power supply voltage to drop, so that the power supply voltage does not reach the input voltage required by the driver, so that the drive module performs undervoltage protection. The broken output causes the motor to stall. The motor interface must not be short-circuited, otherwise the drive module may be burned. It is recommended to connect the 10A fuse at the motor interface. The driver should be connected to the motor before powering up to prevent accidental short circuit and burn the drive module.Be careful not to get wet of the drive. Do not short-circuit the components on the drive board. ...